DMU-2000 D
ATA
M
ANAGEMENT
U
NIT
Page 1
DM
U
TR
X
KEYBOARD
Supplied Connection Cable
MONITOR
~AC IN
~AC IN
An
te
nn
a
I
NSTALLATION
AND
C
ONNECTION
1
. Make certain that all cables are disconnected from
the transceiver.
2
. Referring to Figure 1, remove the three screws from
each side of the transceiver, and three screws from
the top edge of the rear panel. Slide the top cover to-
ward to the rear about 1/2 inch (1 cm), then remove
the top cover.
3
. Refer to Figure 2 for the mounting location for the
SCOPE Unit. Locate the 14-pin plug taped on the chas-
sis. Remove the tape and remove the 14-pin plug from
the chassis.
4
. Mount the SCOPE Unit using the supplied four screws
(Figure 3).
5
. Referring to Figure 4, plug the 14-pin plug which was
removed from the chassis in the previous step into
the J7002 connector on the SCOPE Unit.
6
. Locate the Coaxial plugs (labeled
and
) installed
in jacks (J4508 and J4507) on the RX-2 Unit. Un-
plug the Coaxial plug (
) from the RX-2 Unit and
plug it into the J7003 on the SCOPE Unit. Unplug the
Coaxial plug (
) from the RX-2 Unit and plug it into
the J7001 on the SCOPE Unit (Figure 4).
7
. Replace the top cover and its nine screws.
8
. Assemble the transceiver, Data Management Unit,
after-market Display, and after-market Keyboard (if
used) pursuant to Figure 5.
Figure 1
Figure 2
Figure 3
SCOPE Unit Mounting Location
14-pin Plug
Figure 4
14-pin Plug
SCOPE Unit
RX-2 Unit
Figure 5
Move the Coaxial plug
Move the Coaxial plug
Keep a inch (2.5 cm) of space on ei-
ther side of the
DMU-2000
to pre-
vent the overheating.