DR-2X / DR-2XE Operating Manual
22
z
Delete the registered DP-ID
1
Touch [
A SETUP
] or [
B SETUP
] to display the frequency set up screen, then touch [
F
] on the bottom of the
screen.
2
Touch [
ID MODE
] to select the “DP-ID”.
Touching
[
ID MODE
] switches the setting as follows:
à
“DP-ID”
à
“DG-ID”
à
“DP-ID”
à
The DP-ID display returns to the DG-ID display in about 5 seconds.
3
Keep touching [
ID MODE
] (DP-ID) for more than two seconds.
The DP-ID list screen appears.
8
4
D G - I D
T - O F F
R - O FF
D T M F
* 2 2 2 2
* 3 3 3 3
* 4 4 4 4
1
D E A C T I V A T E
F I X D I G I T A L
A U T O
REG
D P - I D L I S T
F T 2 D R
x x x x x
2 F T 1 X D R
x x x x x
4
Touch the desired DP-ID to delete.
DELETE (Deletion Confirmation Screen) appears.
5
Touch the [
OK?
] to delete or touch the [
Cancel
] to return to the DP-ID
list screen without deleting.
• If deleting another transceiver, repeat step 4 to 5.
6
Touch [
BACK
].
The screen returns to the setup screen.
D T M F
* 2 2 2 2
* 3 3 3 3
* 4 4 4 4
1
D E A C T I V A T E
F I X D I G I T A L
A U T O
REG
D P - I D L I S T
F T 2 D R
x x x x x
2 F T 1 X D R
x x x x x
O K ?
Cance
DELETE
• If using the DP-ID, select the FIX Digital mode in the operation mode screen. When transmitting the DP-ID
signal, set the transceiver to C4FM mode.
The system manager may control the repeater setting remotely from designated transceivers by using this
function.
The transceivers compatible with the remote-control is the FTM-400D and FTM-100D.
Example:
• Sets the repeater function ON or OFF (only the locally connected repeater, or all the linked repeaters)
• Changing Downlink Transmission Power
• Recording / Playing / Clearing the Voice Message
• Setting of the Emergency Call