Yaesu DR-2X, Руководство по эксплуатации, Страница: 13 / 52

DR-2X / DR-2XE Operating Manual 11
RX indicator This indicator shows green when a signal is received and white when there is no signal.
TX indicator This indicator shows red when the repeater transmits and white when there is no transmit.
PRI indicator This indicator shows when the channel is set to the Priority Channel.
CNTL indicator This indicator shows when CH-B is set as the dedicated control channel, and it does not
repeat.
[ REMOTE
] Displayed in red when remote operation with an external controller is enabled (see page 42).
Displayed in red (blinks) when optional LAN Unit LAN-01A is enabled.
[
A SETUP
] Touch here to switch the display to set up the frequency on CH-A.
[
B SETUP
] Touch here to switch the display to set up the frequency on CH-B.
3. Set up Frequency
Set up Dual Receive Frequency
DR-2X/DR-2XE is equipped with dual receive feature that may receive two different frequencies in the VHF
and the UHF Band of Amateur radio bands, so the other uplink and downlink frequency for emergency
communications may be set separately from the normally used frequency.
 8 4  
 3 4  


TX (downlink)
RX (uplink)





Status display area
A green bar is displayed during receive when signals are detected.
The bar will not be displayed when the squelch is turned on and the received signal level is below the
squelch level.
VOL/SQL level display
S-meter level display
PO-meter level display
Mode display
Firmware Version Information
RX ver x.xx: RX-UNIT CPU Firmware Version
TX ver x.xx: TX-UNIT CPU Firmware Version
PANEL ver x.xx: PANEL-UNIT CPU Firmware Version
DSP ver x.xx: DSP Firmware Version
 8 4  
 3 4  
à
*
  
  
  
 #
A
B
C
D
Space
ENT
 8  .  7 UP LINK
Touch [ A SETUP
] to display the CH-A frequency set up screen, then set the uplink and downlink frequency.
Touch the uplink frequency of CH-A, the numeric input popup screen appears. Input the uplink frequency.