Yaesu CT-39A, Руководство по эксплуатации

Страница: 60 / 72

58 FT-8800R Operating Manual
You can transfer all data stored in one FT-8800R to another FT-8800R by utilizing the
handy “Cloning” feature. This requires a user-constructed Cloning cable which connects the
DATA jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure:
1. Insert the Cloning Cable into the
DATA
jack of each transceiver.
2. Turn both transceivers off, then press and hold in the “ left ” [ V/M
] key on each radio
while turning the power on again.
3. Rotate the “ right ” DIAL knob on each radio to select ( CLONE START ), then press the
[
SET
] key. The display will disappear for a moment, then the “
CLONE ” notation will
appear on the display.
4. On the “ destination ” radio, press the “
left
” [
LOW
] key. The “
CLONE -RX- ” indicator
will appear on the display.
5. Now, on the “ source ” radio, press the “left” [
V/M
] key. The “
CLONE -TX- ” indicator will
appear on the display, and the cloning data transfer will immediately begin.
6. If there is a problem during the cloning process, “ CLONE ERROR ” will be displayed.
Check your cable connections, and try again.
7. If cloning was successful, the “ CLONE -RX- ” and “ CLONE -TX- ” indicators will disap-
pear.
8. Turn both transceivers off, then remove the Cloning Cable. Channel and operating data
for both radios are now identical. They both may be turned on now for normal operation.
13.8VDC
ANT
EXT SP
DATA
13.8VDC
ANT
EXT SP
DATA
PKS
GND
C
LONING