Yada YD-V43, Руководство пользователя

Страница: 9 / 26

7
Power Cable (Part G) into the Wireless Signal
Booster.
d. Determine the best place to mount the Signal
Booster. Now it is time to install the camera
5� Remove your license plate
6. Determine the best route for the Camera Cable
from the top of your license plate to the Signal
Booster. You may need to drill a small hole in the
panel behind where the license plate is situated.
7. Take the Camera (Part E) and run the attached
cable through the Rubber Ring Grommet (Part
F), then from the outside of your car to the inside
where the Signal Booster is. Pull the cable through
so that there is a small amount of slack and you can
still move the Camera around the license plate.
3. Determine the reverse light power wires for your
car, designating the positive and negative wires.
If you are not sure of which are the power wires,
then please contact your vehicle manufacturer or
reference a wiring diagram for your vehicle.
4. Connecting the Power Cables:
a. Take the open wire end of this cable, and connect
it to the power wires of your car (as determined in
step 3). Using the Scotchlok Connectors, connect
the Camera’s Red wire to reverse light’s Positive
wire. Connect the camera’s Black Wire to reverse
light’s Negative wire.
b. Use pliers to squeeze the metal tabs of
the Scotchlok Connectors and ensure a solid
connection, then snap the plastic cover closed
c. Place the fixed adapter from the Signal Booster