Yada YD-V43, Руководство пользователя

Страница: 8 / 26

6
7. At this time you can trim off any excess strap with
a scissor.
8. Remove the Yada mirror protective overlay.
9� Now power the mirror.
a. 12V Power Adapter
i. Take the 12V Power Adapter (Part C)
and plug in adapter to top of the Yada
mirror. Plug other end into 12v Power
Port in your car.
b. Hard wire
i. Take the Hard Wire Power Adapter
(Part D) and plug adapter into the top
of the mirror. Run cable to fuse box
and connect to fused accessory power
source.
Refer to your vehicle owner manual for
location of available accessory fuses.
10.At this time, the Yada mirror is ready to be
powered on and can be used as a Bluetooth®
Speaker for your car.
Camera Installation
– uses parts
E
through
k
Note:
Camera installation on diesel vehicles requires
special wiring. Please visit our FAQ’s at www.
letsyada.com or call customer support for additional
instructions.
Caution: This unit is designed to operate on a 12V DC
NEGATIVE GROUND electrical system. Connecting to
other types of electrical systems will cause damage
to your vehicle. Please contact the manufacturer if
you are unaware of the system type in your vehicle.
At the end of this step, the Camera will be mounted
on the back of your license plate, with the cables
connected and ready to set up the Wireless Signal
Booster.
1� Locate the reverse tail lights wiring in your trunk
or rear hatch. You may need to remove the interior
panel in order to locate. You only need to attach the
signal booster power wire to ONE of the tail lights,
not both. If you cannot manually locate the tail light
cables, please contact the vehicle manufacturer or
reference a wiring diagram for your vehicle.
2� At your tail light, remove the light bulb socket
from the reverse light housing.