— 32 —
The message with PGN 130314 (Actual Pressure) will pass the Global_Tx filter only if sent by a device
with NMEA 2000 address 10 or 11. It passes the Raw_Tx filter in RAW mode (because filter
in this configuration pass all messages), but will be blocked by the N2K_Tx filter in N2K mode (this filter
passes 130310 messages only).
3. RESET command
This command accepts one argument:
•
RESET FILTERS. Removes all records from all filters and switches types to BLACK (see previous
section). This corresponds to the factory configuration of filters.
•
RESET SETTINGS. This command resets all settings to factory values (including filters).
•
RESET HARDWARE. EEPROM contains a copy of firmware file uploaded at the factory. After
any firmware update, you can return to your initial firmware and return your Device to factory state.
All settings are reset during this operation.
• RESET MCU. Reboot the Device.
4. SET command
In the current firmware version, this command can only manage the silent mode setting (see chapter V).
To turn on and off the silent mode, type:
SET SILENT ON
SET SILENT OFF
In the future firmware updates the list of arguments for this command will be extended.
5. DIAG command
This command is used to display the record of diagnostic data (see next chapter for details).
Due to the possibility of a large amount of data, the DIAG command requires at least one argument:
Содержание YDNU-02RM
Страница 26: ...26 Figure 2 Welcome screen of the service menu...
Страница 29: ...29 Figure 1 Example of configuration of incoming filters...
Страница 52: ......
