Xytronic LF-855D, Руководство по эксплуатации

Страница: 14 / 17

13
NEW TIPS
Applying the following steps give the tip optimum life.
1.
Set both temperatures to min. then turn the main power switch to the “ON”
position.
2. Set soldering tip temperature to 250
℃
(500
℉
approx.) and desoldering tip
temperature to min. Coat the tinned surfaces with rosin-core solder after reaching
250
℃
.
3. Set to the desired temperature about 3 minutes after being warmed that the station
will be ready for sue once it reaches preset temperature.
IMPORTANT:
Remove and clean the tip daily. If a new tip is installed, remove any loose build up
in the barrel assembly, otherwise the tip may fuse to the heating element or
retaining barrel.
1. collector tube.
2. Depress vacuum witch, clean the tip tube with spring wire provided if there is no
suction per the “Procedure for Cleaning Clogged Tip” section below.
B: Hot air function option
OPERATING PRECAUTIONS
1. Make sure both heater and nozzle are cool before attaching the nozzle.
2
.
Caution High Temperature Operation
Both nozzle and hot air are extremely hot and can cause burns. Never touch the
nozzle and heater assembly or allow the hot air to blow against your skin. Initially,
the iron may emit white smoke, but this will soon dissipate.
Operation Setup
1. Select the Nozzle that matches the size of the IC. Attach the nozzle when both
heating element and the nozzle are cool and the unit is turned off and unplugged.
2. Loosen the screw on the nozzle and attach nozzle.
3. Press “▲” or“▼”key on the hot air function panel to choose the desired
temperature or air flow.
4. Press “▲”or “▼” key to choose the desired air flow on the right side of the front
panel. The speed will change 5 degrees by pressing the keys “▲” or“▼” at a time.
5. After adjusting the air flow and temperature and wait for the temperature to
stabilize for a short period of time.
IMPORTANT : Do not force the nozzle or pull on the edge of the nozzle with pliers.
Also, do not tighten the set-screw too tightly.