Xylem YSI rQPOD, Руководство пользователя

Страница: 21 / 24

21
Battery Charging
1. Do NOT attach the batteries to wall outlets or car charger sockets directly and always use a DJI approved
adapter. DJI takes no responsibility if the battery is charged using non-DJI charger.
2. Never leave the battery unattended during charging. Do NOT charge the battery near flammable materials or
on flammable surfaces such as carpet or wood.
3. Do NOT charge battery immediately after mission, because the battery temperature may be too high. Do
NOT charge the battery until it cools down to near room temperature. Charging the battery outside of the
temperature range of 0°C – 40°C may lead to leakage, overheating, or battery damage.
4. Disconnect the charger when not in use. Examine the charger regularly for damage to the cord, plug, enclosure,
or other parts. Do NOT clean the charger with denatured alcohol or other flammable solvents. Never use a
damaged charger.
5. The Intelligent Battery is designed to stop charging when it is full. However, it is good practice to monitor the
charging progress and disconnect the batteries when fully charged.
Battery Storage
1. Keep batteries out of the reach of children and pets.
2. Do NOT leave the battery near heat sources such as a furnace or heater. Do NOT leave the batteries inside a
vehicle on hot days. The ideal storage temperature is 22°C – 28°C.
3. Keep the battery dry. Never drop the battery into water.
4. Do NOT drop, strike or impale, or manually short-circuit the battery.
5. Keep the battery away from metal objects such as glasses, watches, jewelry and hairpins.
6. Never transport a damaged battery or a battery with power level higher than 50%.
7. Discharge the battery to 40% - 65% if it will NOT be used for 10 days or more. This can greatly extend the
battery life.
8. The battery automatically discharges below 65% when it is idle for more than 10 days to prevent is from
swelling. It takes approximately 3 days to discharge the battery to 65%. It is normal that you may feel moderate
heat emitting from the battery during the discharge process. Set the discharging thresholds in the DJI GO app.
9. The battery will enter hibernation mode if depleted and stored for a long period. When in hibernation mode, if
you try to power on the battery, the battery power LED will show a solid red light and the battery level LEDs will
all be off. You cannot manually turn off the battery power LED in this state. Leave the battery unattended for 5
minutes and then the light will turn off. Recharge the battery to bring it out of hibernation.
10. Remove batteries from the aircraft when stored for an extended period.