Xylem WTW OxiTop-IDS, Руководство по эксплуатации, Страница: 33 / 36

Multi 3630/3620 IDS Firmware update for OxiTop
®
-IDS measuring heads
ba77045e01 09/2019
33
8 Firmware update for OxiTop
®
-IDS measuring
heads
Available firmware updates for OxiTop
®
-IDS measuring heads are provided on
the Internet. With the "Firmware Update " program and a PC you can update the
firmware of a OxiTop
®
-IDS measuring head to the newest version.
For the update you have to connect the Multi 3630/3620 IDS meter to a PC via
the USB interface and start the update program at the PC.
The update requires:
 a free USB interface (virtual COM port) on the PC
 the current driver for the USB interface
(see operating manual of your meter)
 the current firmware for the meter
(see operating manual of your meter)
 the current firmware for the WLM-M adapter
(see operating manual of your WLM system)
 the USB cable (included in the scope of delivery of the Multi 3630/3620 IDS).
After switching the Multi 3630/3620 IDS meter off and on you can check whether
the OxiTop
®
-IDS measuring head has taken over the new software version (see
Multi 3630/3620 IDS operating manual).
1 Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder for the OxiTop
®
-IDS measuring head is already exist-
ing, the new data are displayed there.
2 In the windows start menu, open the update folder and start the firm-
ware update program for the OxiTop
®
-IDS measuring head.
3 Using the USB interface cable, connect the Multi 3630/3620 IDS to a
USB interface (virtual COM port) of the PC.
4 Switch on the Multi 3630/3620 IDS.
5 At the OxiTop
®
-IDS measuring head in the Service menu, start the
update (with Update mode , see operating manual OxiTop
®
-IDS mea-
suring head). The firmware is loaded and automatically installed.
6 In the firmware update program at the PC, start the update process with
OK.
7 Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 5 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
8 Disconnect the Multi 3630/3620 IDS from the PC.
The meter and OxiTop
®
-IDS measuring head are ready for operation
again.