Xylem wtw MIQ/IDS, Руководство по эксплуатации

Страница: 46 / 62

Turbidity MIQ/IDS
46
ba77277d01 01/2024
9 Turbidity
The MIQ/IDS module connects IDS sensors to the IQ S
ENSOR
N
ET
.
Suitable sensors: see section 9.5 A
CCESSORIES
9.1 Measuring
Prerequisites

The IQ S
ENSOR
N
ET
system is in operation
(see IQ S
ENSOR
N
ET
system operating manual).

The sensor is connected to the MIQ/IDS module
(see section 3.7).
Preparatory activi-
ties
Perform the following preparatory activities when you want to measure:
 Avoid gas bubbles (e.g. air bubbles) in the test sample.
 Use suitable vessels for measurement and calibration
(see operating manual of the VisoTurb
®
900-P sensor).
 Heed the minimum depth of immersion for the sensor
CAUTION
Contact with the sample can lead to danger to the user!
Depending on the type of sample, suitable protective mea
-
sures must be taken (protective clothing, protective goggles,
etc.).
1. Install the sensor in a flow through armature and provide the sample flow.
or
For measurement and calibration in containers:
Prepare the sensor for measurement (see
P
REPARATORY ACTIVITIES
, page
46).
1.
Fill the test sample into a lightproof measuring beaker up to a level of at
least 6 cm.
2.
When immersing the sensor in the test sample, hold the sensor at an
angle.
3.
For measuring, position the sensor upright.