Xylem wtw CarboVis 701 IQ TS, Руководство по эксплуатации

Страница: 22 / 60

Commissioning
CarboVis 70x IQ TS
22 ba75950e03 05/2017
3.4.5 Settings of the secondary sensor (TSS measurement)
Carrying out
settings
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
ENSOR
N
ET
system operating
manual.
Default values are marked in bold.
Measuring location

Outlet

Inlet

Activation
Measurement location or application of
the sensor.
The setting is done in the setting menu
of the relevant main sensor.
Measuring range
- Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).
Cal - # raw value 1
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission
-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Main sensor
Information that there are further sen
-
sor overlapping settings in the setting
menu of the relevant main sensor
(
Meas. interval
,
Cleaning duration Air
,
Signal smoothing
etc.).
Save and quit
- The system confirms the saving of the
settings and the display switches to the
next higher level.
Quit
- The display switches to the next higher
level without storing the new settings.
* The UVT-254 value is standardized to 10 mm gap width.
Menu item Settings Explanations
Menu item Settings Explanations
Measuring mode TSS
Display of the measuring mode
(TSS = total suspended solids measure
-
ment)
Measuring range
- Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).