6
I.
Check that you have received
the correct C-Warm heater and
accessories. Check immersion
heater power and voltage.
Report any damage or
discrepancies to your supplier
without delay.
II.
Check the dimensions of the
heater and recheck the
dimensions of the space for its
installation in your boat.
III.
Read through these instructions
carefully, noting additional items
required for installation.
Your C-Warm water storage heater may be located in any convenient and
accessible position subject to the following considerations:
I.
With pumped cooling water
circulation, the storage heater
can be located above or below
engine level. For best circulation,
natural convection should assist
the pumped flow.
II.
There must be no air locks in the
cooling water circuit. Either
locate the water storage heater
with its upper coil connection
below the engine’s water filling
point, or fit an auxiliary
header/filler tank above the
highest point in the cooling water
circuit. See page 7.
III.
The longer the pipe run
between water storage heater
and engine, the more work the
engine’s cooling water
circulation pump has to do.
Minimise the reduction in water
flow rate by locating the
storage heater near the engine.
IV.
Vertical C-Warm storage heaters
MUST be mounted vertically,
horizontal heaters MUST be
mounted horizontally.
BEFORE YOU START
LOCATION
