16
1
Check that the pipework is complete
and fully connected.
2
If necessary, refill the engine cooling
system with the recommended
coolant.
3
To fill your pressurised water system,
including your C-Warm heater, with
water proceed as follows:
●
check that the pipe work is
complete and fully connected
●
open all the hot and cold outlets
●
fill the cold water supply tank
●
open the isolating valve from the
water supply tank to the
pressurised system
●
start the pump, which should prime
itself in a few seconds. The system
will begin to fill with water. As the
system fills up, the taps will start to
discharge air and water. Close
each tap slowly, until only one hot
tap remains open. When this tap
stops discharging air, the C-Warm
heater is full. Close the tap. The
pump will stop within a short time.
●
check all the fittings and
connections thoroughly for leaks
●
test the temperature-and-pressure
relief valve by rotating the coloured
knob one full turn anticlockwise;
water should flow freely from the
valve discharge
●
refill your water storage tank
●
check all the connections once more
when the water is heated for the first
time.
4.
Your pressurised system and C-Warm
heater are now ready for use.
5.
Your engine cooling circuit will heat the
stored fresh water in your C-Warm
heater automatically, whenever you run
the engine. The engine cannot
overheat C-Warm: once the stored
water has reached its maximum
temperature, no added heat is
absorbed from the engine cooling
circuit.
6.
C-Warm’s efficient installation will keep
the stored water hot for many hours after
you have stopped the engine
7.
If the stored water is too hot, check the
C-Warm Instructions to find out how to
limit its temperature
8.
An electric immersion heater will switch
itself on and off automatically, just as in
a domestic water tank. Reset the main
thermostat in the immersion heater if
necessary (factory setting is 60ºC). Do
not adjust the high temperature cut-out
thermostat (factory setting is 85ºC).
9.
Use your hot and cold water outlets just
as you would at home.
10.
Apart from checking the operation of
the temperature-and-pressure relief
valve once a week (see instructions)
your C-Warm storage heater needs no
regular maintenance. Don’t forget to
drain it when you store the boat for the
winter!
USING THE HEATER
