Xylem Bell & Gossett e-80SCXL Series, Инструкция по эксплуатации

Страница: 25 / 36

10, 11
3
7
6
4
8, 9
2
1
5
Figure 8: Outside seal
1. Seal seat
2. Seal gland
3. Seal seat gasket (seat to cap or gland)
4. Seal seat gasket (seat to cover)
5. Shaft
6. Cover
7. Motor bracket
8. Seal gland cap screws
9. Washers
10.Rotating part of the seal
11.Seal set screws
10.For an inside seal:
a) Lubricate the bore of the rotating part of the seal with soapy water or other suitable
lubricant such as International Products Corporation P-80
®
, and install the seal on the
shaft with the rotating face up toward the motor until it contacts the snap ring.
b) Install the seal seat with seal cap or gland (with the gasket between the cap and the
motor bracket) over the end of the shaft and affix to the motor bracket with four cap
screws and washers. Tighten seal gland cap screws evenly to avoid misalignment
one quarter turn past hand tight.
c) The seal is now fully installed and will be set after coupling assembly.
4
5
9, 10
7
6
1
8
3
2
Figure 9: Inside seal
1. Rotating part of the seal
2. Shaft
3. Snap ring
4. Seal seat
5. Seal cap
6. Seal gasket
7. Cover
8. Motor bracket
9. Seal cap screws
10.Washers
6 Maintenance
Series e-80SCXL INSTRUCTION MANUAL 23