Xycom XVME-560, Руководство пользователя

Страница: 26 / 70

XVME-560 Manual
September, 1984
2.6.1 Installation Procedure
CAUTION
Do not attempt to
install or
before turning off the power
related external power supplies.
remove any boards
to the bus and all
Prior to installing a module, determine and verify
all relevant jumper configurations and all connec-
tions to external devices or power supplies. (Please
check the jumper configuration with the diagram
and lists in the manual.)
To install a board in the cardcage, perform the following steps:
1)
Make certain that the particular cardcage slot you are going to use is clear
and accessible.
2)
Center the board on
the
plastic guides
so that the solder side is facing to
the
left and the component side is facing to
the right (refer to Figure
2-6).
3)
Push the card slowly toward the rear
of the
chassis
until the connectors
engage
(the board
should slide freely in the plastic guides).
4)
Apply straight-forward pressure to the two handles on the outer edge of
the
board
until the connectors are fully engaged
and
properly seated.
NOTE
It should not be necessary to use excess pressure or
force
to engage the connectors. If the board does
not
properly connect
with the backplane, remove
the module and inspect all connectors and guide
slots for possible damage or obstructions.
5)
Once the board is properly seated, it should be secured by tightening the
two machine screws at the extreme top and bottom of the board.