Xycom 3510T, Руководство пользователя

Страница: 73 / 107

Chapter Five – Keypad Utility for 3535
73
Chapter 5 - Keypad Utility for the 3535 KPM
The 3535KPM Keypad Utility lets users redefine all keypad keys with new scan
codes using utility software. Use an external full-stroke PC/AT keyboard to access
the utility (you cannot redefine the keyboard).
Note
The keypad switch arrays are disabled while the keypad utility is running.
Loading the Keypad Utility
Note
You need MS-DOS

3.2 or higher to run the keypad utility. It will not work if you are
running Windows

95 or Windows NT

. However, the keypad utility will run under
Windows

95 in DOS mode.
You can run this utility directly from the disk or copy it onto your hard drive. To run
the keypad utility from the disk, change the directory to the appropriate drive and
type
kputil
. To load the utility onto your hard drive, create a subdirectory for the files,
and copy all the files on the disk into that subdirectory. Enter the subdirectory and
type
kputil
.
Using the Keypad Utility
The keypad utility uses a menu bar and pull-down menu system. All menu bars are
displayed across the top of the screen. “Xycom Automation KP Utility” and the
current menu titles are shown at the bottom of the screen (see Figure 4-1).
A full-stroke keyboard is needed to enter keystrokes while recording a new key
macro, editing an existing macro, and entering utility commands. You can redefine
all keys on the keypads. While the utility is running, the keypads are disabled.
Dialog boxes appear for user prompts and to display error and user advice messages.
Two keys allow you to exit the menus:
•
ESC moves to the previous menu or out of the utility from the Main Menu.
•
F1 returns to the current menu headings in some of the menus where Exit can be
chosen to exit this menu.
Keys specific to each menu are shown at the bottom of each screen.