Xtreme Power 82104, Инструкция по эксплуатации и правила безопасности

Страница: 7 / 16

6
A new chain will expand its length in the beginning of use. Check and readjust the tension frequency as
a loose chain can easily derail or cause rapid degradation of the chain as well as the guide bar.
FUEL AND CHAIN OIL
: Mix gasoline (leaded or
unleaded, alcohol-free) and quality proven 2-stroke motor oil
(FC grade) for air cooled 2-cycle engines.
Most engine troubles are caused, directly or indirectly, by the fuel used on the machine. Take special
care not to mix a motor oil for 4-cycle engines.
Chain Oil: Use motor oil SAE#10W-30 all year round or SAE#30-#40 in colder temperatures.
STARTING THE ENGINE :
1.
Fill the fuel and chain oil tanks respectively and tighten the caps securely.
(F7)
2. Set the switch to the “1” position (F8)
3. While holding the throttle lever together with the throttle interlock, push in
the side throttle lock button and release the throttle lever to hold it at the starting
position. (F9)
1. Chain Oil
2. Fuel
3. Switch
4. Throttle Lock Button
5. Throttle Level
6. Throttle Interlock
7. Choke Knob
4. Pull out the choke knob to the closed position. (F10)
5.
While holding the Chainsaw unit securely on the ground, pull the starter
rope vigorously. (F11)
6.
When the engine has ignited first, push in the choke knob and pull the
starter again to start the engine.
7.
Allow the engine to warm up the throttle lever pulled slightly.
Note: When restarting immediately after stopping the engine, leave the choke
knob at the open position.
Note: After Starting the engine, run the chain at medium speed and see if the
chain oil is scattered off as shown. (F12)
DIAGRAMS AND SPECIFICATIONS