Xtreme Power 82104, Инструкция по эксплуатации и правила безопасности

Страница: 6 / 16

5
GUIDE BAR AND SAW CHAIN PARTS LIST : A standard chainsaw unit package contains the
items illustration in Figure F1. Open the box and install the guide bar and the saw chain on the
power unit as follows.
1. POWER UNIT
2. BAR PROTECTOR
4. CHAINSAW
5. PLUG WRENCH
6. SCREWDRIVER FOR CARBURETTOR ADJUSTMENT
7. SPIKE AND MOUNTAIN SCREWS
The chainsaw has very sharp edges. Use thick protective gloves for safety.
WARNING:
The features include on your chainsaw are to help prevent the hazard of kickback; however,
such features will not eliminate this danger. As a chainsaw user, do not rely only on safety devices
alone. You must follow all safety precautions, instructions and maintenance in this manual to help avoid
kickback and other forces which can result in serious bodily injury.
3. GUIDE BAR
1. Pull the guard towards the front handle to check the
chain brake is not on.
2. Loosen the nuts and remove the chain cover.
4.
Gear that chain to the sprocket and while fitting the
chain saw around the guide bar, mount the guide bar to
the power unit. Adjust the position of the chain tensioner
nut on the chain cover to the lower hole of the guide bar.
(F2)
3. Install the attached spike to the power unit.
(8) Hole (9) Tensioner Nut (10) Chain Cover
1 . Moving direction
2. Fit the chain cover to the power unit and fasten the nuts
to finger tightness.
4.
Tighten the nuts securely with the bat tip held up (12-
15N.m). Then check the chain for smooth rotation and
proper tension while moving it by hand. If necessary,
readjust with the chain cover loose.
3. While holding up the tip of the bar, adjust the chain
tension by turning the tensioner screw until the tie straps
just touch the bottom side of the bar rail. (F4)
Pay attention to the correct direction of the saw
chain. (F3)
5. Tighten the tensioner screw.
(2) Loosen (3) Tighten (4) Tensioner Screw
DIAGRAMS AND SPECIFICATIONS