Xtreme Power 82100, Инструкция по эксплуатации и правила безопасности

Страница: 13 / 16

12
1.
Lay out your tools
2.
Mix the oil
3.
Check that the chain brake is in the unlocked position by pulling the front hand guard toward the front
handle
4.
Loosen and remove the bar nuts and the clutch cover from the saw
5.
An adjusting pin and screw are used to adjust the tension of the chain. It is very important when as-
sembling the bar that the adjusting pin aligns in a hole in the bar. Turning the screw will move the adjust-
ing pin up and down the screw. Locate this adjusting pin before you begin mounting the bar into the saw.
6.
Turn the adjusting screw by hand until the adjusting pin is positioned between the indicator marks, this
should allow the adjusting pin to be near the correct position.
7.
Slide the guide bar with chain on bar bolts. Cutters must face in the direction of rotation.
8.
Check that the drive links of the chain fit correctly on the drive sprocket and that the chain is in the
groove on the bar.
9.
Fit the clutch cover and insert the adjusting pin in the cut out in the bar
10.
Tighten the bar nut finger tight
11.
Tension the chain by turning the chain tensioning screw clockwise. The chain is correctly tensioned
when it does not sag from the underside of the bar but can still be turned easily by hand.
12.
When fitting a new chain, the chain tension has to be checked frequently until the chain is run-in.
Check the chain tension regularly.
Scan the QR code below to watch a video on assembling your new XtremepowerUS
45cc Gas Chainsaw:
QUICK START GUIDE