Xtreme Power 82100, Инструкция по эксплуатации и правила безопасности, Страница: 10 / 16

Clean the electrodes with a wire brush and reset the gap to .65mm as
necessary.
SPARK PLUG:
Check for cracks as well as for excessive wear interfering with the
chain drive. If the wearing is found, replace it with a new one. Never fit
a new chain on a worn sprocket nor a worn chain on a new sprocket.
SPROCKET:
(1) Sprocket
(2) Needle Bearing
(3) Clutch Drum
(4) Spacer
(5) Clutch Shoe
Disassemble the filter and wash with gasoline or replace with a new
one.
FUEL FILTER:
Replace if the adhered part is peeing or cracked, on the rubber part.
SAW CHAIN:
9
Place your file on the cutter and push straight forward, keep the file
position as illustrated. (F31)
After every cutter has been set, check the depth gauge and file it to the
proper level as illustrated. (F32)
Be sure to round off the front edge to reduce the chance of kickback
or tie-strap breakage.
Make sure every cutter has the same length and edge angles as
illustrated
(1) Appropriate gauge checker
(2) Make the shoulder round
(3) Depth gauge standard
(4) Cutter length
(5) Filing angle
(6) Side plate angle
(7) Top plate cutting angle
Reverse the bar occasionally to prevent partial wear.
GUIDE BAR:
The bar rail should always be a square. Check for wear of the bar rail.
Apply a ruler to the bar and the outside of the cutter. If a gap is observed
between them, the rail is normal. Otherwise, the rail is worn. This will need
to be repaired or replaced.
GUIDELINES