Xtreme Power 81094, Инструкция по эксплуатации и правила безопасности

Страница: 7 / 12

6
1. Stand with a solid stance on stable ground. Brace yourself and maintain a proper grip with both hands on
the Frame (1b) whenever the engine is running. See Figure E.
2. Accelerate the engine to full throttle just before starting to drill by squeezing the Speed Control (10b) Also,
keep the engine at full throttle the entire time you are drilling, unless a problem arises.
3. Do not attempt to drill at an angle. Always Keep the Auger vertical .
4. Allow the Auger to do most of the work. Exert only minimal pressure downwards. Attempting to force the
drill can cause permanent damage to the unit. Be cautious that the drill will have strong twisting force during
operation.
5. Release the Speed Control as soon as drilling is complete, let the engine idle. Running the Auger Drill at
full throttle without a drilling load can cause unnecessary wear or damage to the unit.
6. After running the drill for an extended period, allow the engine to idle for several minutes to allow heat to
dissipate. This will prevent system parts like the ignition, piston rings, carburetor etc. from being damaged
by overheating. Once you have done this press the Kill Switch (5b) to turn off the engine. See Figure E.
7. Before storing the Auger Drill, make sure to drain all fuel from the fuel tank (89). Failure to do so may
cause old fuel left in the tank to clog the carburetor and prevent start up until it is cleaned out. Once you
have emptied the fuel tank, store the Auger Drill in a clean, dry, safe location. Keep out of reach of children.
See Figure E.
DRILLING A HOLE
1. WARNING: Remove the Spark Plug (51) and allow the engine to cool completely prior to performing any
service, maintenance or cleaning of the Auger Drill.
2. Before Each Use: Inspect the general condition of the Auger Drill. Check for misalignments or binding of
moving parts, cracked or broken parts, dull or damage parts or any other condition that may affect the safe
operation of the unit. If abnormal noise or vibration occurs, have the problem inspected by a professional
before further use. Do not use the unit if damaged.
INSPECTION, MAINTENANCE AND CLEANING
OPERATION