18
HELP
Propellers are spinning, but the Drone will not lift off the ground.
•
Check the propellers for any sign of damage. Bent or broken propellers should be replaced promptly with the spare
propellers included in your package.
•
The Drone battery has insufficient power. Make sure the Drone battery has been fully recharged.
The Drone keeps drifting in a certain direction during flight even in calm wind conditions.
•
Check for trapped dirt around the motors driving the propellers. Just a little strand of hair could make the Drone difficult
to control.
•
Adjust the trim to compensate for the drifting. Repeatedly push the appropriate trim button opposite to the direction
the Drone is drifting towards until the drifting stops. For example, if the Drone drifts forward, press the Backward Trim
button, and vice-versa. If the Drone drifts to the left, press the Right Sideway Trim button, and vice-versa. If the Drone
spins counter-clockwise, push the Right Rotation Trim button, and vice-versa.
•
Recalibrate the Drone gyro sensor after a heavy landing. First, place the Drone on a flat, level surface, and then hold
both control sticks to the lower left corner until the status lights on the Drone blink rapidly. When the lights turn solid, the
calibration process is complete.
The Drone responds slowly and does not maintain altitude easily.
•
Battery voltage (power) is running low. Before power to the motors is cut off entirely, gradually lower the throttle stick
until the Drone descends and lands safely, and immediately charge the battery.
•
The Drone has flown outside of the range of the controller. Bring the Drone closer to your position.
Video recording is not clear.
•
Peel off the transparent film wrapped around the camera lens.
•
Signal interference with other 2.4GHz devices in the vicinity of the Drone may cause horizontal lines to intermittently
appear in the video recording.
The controller is blinking and beeping continuously.
•
Batteries need replacing. Insert a new set of AA batteries into the controller.
