XTM Racing Mammoth ST, Руководство пользователя, Страница: 8 / 64

8
❑
Install 4 AA Alkaline batteries into the battery holder, double-checking to make sure
that the polarity is correct.
✦ ✦
✦ ✦ ✦
IMPORTANT
✦ ✦
✦ ✦ ✦
Make sure that the batteries are pushed firmly into place. They should
not be loose. If for any reason the plug from the battery holder (male red plug) is not
plugged into the switch (female red plug), plug them together now. The plugs can fit
together only one way.
If you would like to upgrade to a rechargeable NiMH battery pack, instead of using Alkaline dry cells, we
suggest using the XTM Racing 5 cell 1000mAH NiMH RX Battery Pack (P/N 145801). Not only is this battery
pack rechargeable, but because it's a 5-cell battery, it will operate the servos at a higher power
rating and faster speed. We also suggest upgrading the on/off switch to one that includes a
separate charge cord. The Cirrus On/Off Switch with Charge Cord (P/N 444733) works
well. This will allow you to charge the receiver battery without removing the battery
box cover. When installing the switch, make sure that you leave the charge cord
outside of the receiver box, but secured to the chassis, so it doesn't get damaged.
✦ ✦
✦ ✦ ✦
WARNING
✦ ✦
✦ ✦ ✦
Never attempt to recharge non-rechargeable batteries. The batteries
could explode and cause serious injury.
MAMMOTH ST NITRO STADIUM TRUCK UPGRADE TIP
❑
Remove the four screws from the receiver mounting box cover, then remove the cover.
❑
Uncoil the receiver antenna and feed it out through the hole in the cover.
❑
Reinstall the cover, making sure not to pinch any of the wires.
❑
Open the battery box cover by removing the retaining clip and pulling up on the front of
the cover. The battery box cover is hinged at the back for convenience.
❑
Remove the battery holder from the battery box.
❑
Slide the receiver antenna into one end of the plastic antenna tube and out the
other end.
❑
Push the end of the antenna tube firmly into the metal clamp in the top of the receiver
mounting box cover, then gently tighten the knurled nut to lock the tube into place.
✦ ✦
✦ ✦
✦
IMPORTANT
✦ ✦
✦ ✦
✦
Leave the excess antenna hanging from the top of the tube. Under
no circumstances should you cut the antenna shorter.
Continued On Next Page
☛ ☛
☛ ☛
☛