To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided.
To start the tool, grasp the rear handle (the lock-off lever is released by the grasp) and then pull the
switch trigger.
To stop the tool, release the switch trigger.
Nylon cutting head
The bump feed will not operate properly if the head is not rotating. The nylon cutting head is a
dual string trimmer head provided with a bump & feed mechanism. To cause the nylon cord to
feed out, the cutting head should be bumped against the ground while rotating.
NOTE:
If the nylon cord does not feed out while bumping the head, rewind/replace the nylon cord by
following the procedures described under.
ASSEMBLY
Always be sure that the tool is switched off and battery packs are removed before carrying out any
work on the tool.
Failure to switch off and remove the battery packs may
result in serious personal injury from accidental start-up.
Never start the tool unless it is completely assembled. Operation of the tool in a partially
assembled state may result in serious personal injury from accidental start-up.
Adjusting the grip
Installing the guard
Never use the tool without the guard installed in place. Failure to do so can cause serious personal
injury.
Содержание XT102880
Страница 10: ......
