XtendLan XL-RAID133v2, Руководство пользователя

Страница: 20 / 23

If you want to know further methods of operation about RAIDGuide, please refer to the XL-
RAIDGuide.pdf in our RAIDGuide CD-ROM or
www.xtendlan.com .
Chapter 7 Questions & Answers
Q1: Why is the computer system unable to reboot or re-configure after XL-
RAID133v2 is installed?
A:
1. XL-RAID133v2 supports IDE I/O interface. However, it is not compatible with
motherboards building the ITE IT8680F-A chip. Replace it with another I/O chip
compatible with the XL-RAID133V2 .
2. Check if IDE bus connector is connected properly.
3. Check if power cord connected to XL-RAID133V2 .
Q2: What happens if power is shut down while the XL-RAID133v2 is running?
A:
In case of power failure during the
Auto-Rebuild
Function, controller will
remember the rebuilding progress percentage and carry on the operations when the
power is restored.
Q3: What is the configuration for XL-RAID133v2 (with 1 or 2 hard disks) when
one HDD is already installed?
A
:1. On the same IDE buses, set the jumper for XL-RAID133v2 to MASTER and the
original disk to SLAVE. Otherwise, the original HDD cannot be detected.
2. On different IDE buses, set MASTER or SLAVE for XL-RAID133v2 and original
HDD respectively.
Q4: When using the XL-RAID133V2 , the computer system is unable to read/write
properly.
A:
1. Check if IDE bus connector is inserted properly.
2. Check if IDE bus length is shorter than 46cm or 18”.
(Compliant to ATA 4 specification.)
Q5: The buzzer alarm keeps sounding during XL-RAID133v2 operation.
A:
Check if both Removable Carriers (hard disks installed) on the upper and lower
decks are inserted into the right position. Please refer to section 2-5 Installing HDD
in Removable Carrier and section 2-4 Remove/insert Removable Carrier.
Q6: How to turn on/off the buzzer?
19