XtendLan XL-RAID133v2, Руководство пользователя

Страница: 11 / 23

2-5 Installing HDD in the Removable Carrier
"
Set Master/Slave jumpers to
MASTER
(Important).
"
Connect the power cord and the Removable Carrier’s EIDE/IDE interface cable to the
HDD.
"
Inset the HDD into the Removable Carrier.
"
Fasten the HDD with the attached 6#-32 screws in their four locations. Place the power
cord and the EIDE/IDE interface cable lower than the surface of the HDD in order to
avoid any hindrance when taking out the HDD. Please refer to the following illustration.
2-6 Installing the XL-RAID133v2 in your Computer
"
Turn the power off.
"
Make sure there are two 5-1/4" Expansion bays available for the XL-RAID133v2 .
"
Set up MASTER or SLAVE positions of XL-RAID133v2 according to your needs.
(Factory default:
Master
). If you need to set it to SLAVE, please modify the jumpers on
the back panel of the XL-RAID133V2 .
"
Remove computer case and insert the XL-RAID133v2 into the Expansion bay.
"
Connect power cord and EIDE/IDE interface cable to the right connector.
"
Make sure the direction of power cord, wrong connection will damage XL-
RAID133v2.
"
Fasten XL-RAID133v2 at four places with attached M3×6mm screws, according to the
following illustration.
"
Replace and fasten computer case.
10