XtendLan XL-GFC142M, Руководство пользователя

Страница: 6 / 54

5
2.3 General Rules
Before making any connections to the modem, please note the following rules:

Ethernet Port interface : RJ-45
All network connections to the modem Ethernet port must be made using Category 5e UTP/STP or above
for 1000 Mbps, Category 5 UTP or above for 100Mbps Category 3, 4 UTP or above for 10Mbps.
No more than 100 meters of cabling may be use between the MUX or HUB and an end node.

G.fast Port interface : RJ-11 & Terminal block combo
All network connections to the RJ-11/ terminal block(sharing port) must use 24~26 gauge with single
twisted pair phone wire.
We do not recommend the usage of the other gauge phone wire.
The RJ-11 is an 6P4C connector, two of which are wired. The modem uses the center two pins. The pin out
assignment for these connectors is presented below.
Please note that the line port is no polarity, therefore user can reverse the two wires of the phone cable
when installed.
RJ-11 Pin out Assignments
Pin# MNEMONIC FUNCTION
1 NC Unused
2 2a Pass through
3 1a G.fast / xDSL
4 1b G.fast / xDSL
5 2b Pass through
6 NC Unused