100
Setup left limiting position
112
Start Tour
101
Setup right limiting position
122
Activate Home
Position function
102
Start left/right scan
123
Disable Home Position
function
105
Start 360°scan of the dome
124
Setup Home Position
108
Stop auto scan of the dome
5. Setup the Movement Speed of the Dome
The movement speed of the dome can be setup through the coding switch.
DIP 5 and DIP6 of the 6-button coding switch (see figure above) are used to setup the movement
speed of the dome. Please refer details as Table 5:
No.
DIP: 5
，
6 Circling speed
1
00
6°
2
10
9°
3
01
12°
4
11
15°
Table 5
3-2. Running state examination while Supplying Power to the Unit
Once the power supply begins, check whether the power indicator on the PCB
panel is on. Now the constant speed ball begins with self-check. After the self-check,
the position of the dome is horizontally on the left limiting position, tilt 30º. Two
states may follow the self-check:
a. The constant speed ball makes no action
b. The constant speed ball is in the state of pan auto- touring
If the constant speed ball is in the state of pan auto-touring, the tour should be
stopped through the controlling device to avoid possible friction or collision between
camera cable and inner housing caused by inappropriate installation of the camera.
After installing the vitreous cover, control the constant speed ball to make slow
pan/tilt movement, and observe its agility and stability, and check whether there is
friction or collision between camera, cable and inner housing.
If the ball movement is unstable and with noise, please check whether the
connection between the constant speed ball and the bracket is vertical, or whether the
ball movement is in good connection with the peg-board. If not, switch off the power
supply, then check and re-install the unit following the above-mentioned installation
instructions.
If there is friction or collision between the camera, cable and the inner housing,
switch off the power and open the vitreous cover to adjust the position of the camera
on the suspender, or tidy up the cables inside the inner housing. Then reinstall the
vitreous cover.
