XtendLan IPM-401W, Руководство пользователя, Страница: 9 / 71

- 9 -
Setting up your device
Before we Start
*Before setting up the device make sure of the following:
1.)
All the package contents are all included if anything is missing please contact the dealer
where the device was purchased from.
2.) Check the power input cable is working correctly.
3.) Check all cables to make sure there are no problems with it.
Hardware Connection
Please refer following procedure :
1.) Connect the Ethernet cable (RJ45) to the IPM-401W to your local area
network. 2.) Then connect the power cable into the power input port of the IPM-
401W.
3.) Connect the device that you would like to control to the output plug on the top of the IPM-
401W. 4.) Switching the power source to ON status , this switch is located at the rear of 9258.
5.) After power on for around 45 seconds , there is a short beep sound for IPM-401W which
means the system reboot successfully
5. ) Go to page #14 for software installation guide
– use IP EDIT to log in the webpage of
IPM-401W.
Note: To change the network setting for WiFi connection ( if your Router without WPS function ) ,
please go to page # 12 to setup the WiFi connection manually .
Software Installation
The Media Link - IP Family CD comes with the device , it will have all the necessary software to
run and setup the device.
IP Power Software:
IP Edit (Required)
IP Power Center *( For multiple IP Power devices control )
Installing Software
1.) Place the Media Link-IP Family CD into the CD/DVD Rom drive.
(The CD should auto run but if it does not go to the CD/DVD Rom drive and select the
“
autorun.html
” file.)