Xstream HW152EMD, Руководство по эксплуатации

Страница: 23 / 66

23
operation
HOT WATER OPERATION
WARNING
THE WATER TEMPERATURE COULD BECOME VERY HOT DURING
HOT WATER OPERATION. BE CAUTIOUS WHEN ADJUSTING
PRESSURE OR CONTROLLING THE TRIGGER GUN/ LANCE
ASSEMBLY.
1. Follow the steps 1-8 outlined for “START-UP/COLD WATER
OPERATION”.
2. Move the switch to the “Burner” position. On initial start-up, water
will begin turning hot in approximately 20 seconds and will reach
maximum temperature in approximately 2-1/2 minutes, provided the
trigger remains squeezed. The burner will stop firing when the trigger
is released.
At this point, the unit is operating as a hot water pressure washer. Be
extremely cautious when adjusting the pressure and controlling the
trigger gun/ lance assembly to avoid the possibility of burns.
NOTICE
While spraying, it is normal for the burner to fire intermittently. The high
limit switch will cause combustion to cease when the temperature of
the discharged water exceeds the temperature setting of the switch.
Combustion will begin again when the water temperature drops below
the minimum setting .
STEAM OPERATION (IF APPLICABLE)
1. Follow steps 1-8 outlined for “STARTUP/COLD WATER
OPERATION”.
2. Ensure the quick-connect at the end of the lance is cool enough to
touch, then remove the high pressure nozzle and replace it with the
steam nozzle. Remove the high pressure hose and replace it with the
steam hose.
3. Turn unloader knob completely counterclockwise to the minimum
setting.
4. Turn the switch to “Steam”.
At this point, the unit is operating as a steam pressure washer. Be
extremely cautious when adjusting the pressure and controlling the
trigger gun/ lance assembly to avoid the possibility of burns.