Xstream HW152EMD, Руководство по эксплуатации

Страница: 21 / 66

21
operation
Operating Instructions
FLUSHING THE SySTEM
This unit has a steel coil which, after setting, will cause the water remain-
ing in the coil from the previous usage to turn brown or black. This water
must be flushed from the system before start-up. This procedure should
be performed without the high pressure hose, gun and lance assembly
installed.
1. Turn on the water supply.
2. Low pressure water will begin flowing from the water outlet. This al-
lows the unit to flush any particles from the system. The unit is flushed
when the water is clear.
3. Once the system is flushed, turn off the water supply and connect the
high pressure hose to the water outlet of the unit.
4. Connect the trigger gun and lance assembly to the high pressure
hose.
5. Turn on the water supply.
CAUTION
BE CERTAIN THE HOSE, GUN & LANCE ASSY. ARE NOT
CONNECTED TO THE UNIT WHILE PRIMING THE PUMP. PRIMING
ALLOWS MINERAL DEPOSITS TO BE RELEASED FROM THE
SYSTEM WHICH WOULD OBSTRUCT OR DAMAGE THE GUN
AND NOZZLE ASSEMBLY RESULTING IN COSTLY REPAIRS.
START-UP/COLD WATER OPERATION
WARNING
KEEP CLEAR OF NOZZLE! NEVER PLACE HAND OR FINGERS IN
FRONT OF NOZZLE!
DO NOT DIRECT DISCHARGE STREAM AT PEOPLE OR PETS!
AUTO START/STOP FEATURE WILL SHUTDOWN THE PRESSURE
WASHER UNTIL GUN IS TRIGGERED. TO PREVENT ACCIDENTAL
HIGH PRESSURE DISCHARGE, DO NOT LEAVE UNIT
UNATTENDED WHILE IN THIS MODE.