User Manual
XProHeli DYS 3XBrushless Gimbal
DYS 3X Brushless Gimbal For GoPro
Page 30
©2014 XPROHELI. All Rights Reserved.
DYS 3X Recovery Procedures
Overview
This section provides instructional steps to bring your
DYS 3X back to the original pre-configured settings. In
the rare event that you have to reflash your controller
due to a corrupt file or erased memory bank you can
also use this section as a recovery guide.
Prior to performing the recovery steps your camera
should be mounted and balanced and your gimbal
should be mounted to the DYS 3X stand so that the
gimbal can move about freely on the Roll, Pitch and
Yaw axis.
Recovery Steps:
1.
Load / Write 2.40B8 Firmware (this can be done
using the 2.41B4 GUI in the Upgrade tab)
2.
With Motors OFF in GUI, Load and write Backup
Profiles 1, 2 & 4.
Note: IF you did not backup your Profiles please
email support and we will send you a copy of each.
3.
Connect Battery – Motors Turned OFF in GUI
4.
Perform GYRO Cal (Press Cal Gyro)
5.
Perform 6-Point IMU Calibration
https://www.youtube.com/watch?v=Xb64-
QisyvE&feature=youtu.be
6.
Set Motor Polarity by powering Motors ON and click
AUTO (under Motor Configuration Basic Tab)
a.
Gimbal should rotate each axis and identify
direction of movement. When complete the
