conn.
3
1
1.C
1.B
(CAN SW) Data
(CAN Low) Data
Relay Out NO
Light Green
Orange/Brown
Orange/Green
Brown
1
2
Connect wire to vehicle
INPUT
OUTPUT
5
Connect
the other connectors
(
CONN. 3
)
2
Press
the programming switch
while inserting the main wires
harness (
CONN 1
) into the DLPK
module.
The LED will illuminate to indicate
you are in programming mode,
release the programming button.
IGN
START
OFF
3
Turn the key to the
"ON" position
.
The LED will flash until you
press
the OEM remote lock button
.
If the vehicle is not equiped with the
OEM remote: press on the
programming button of the module.
The LED will turn off to indicate the
module has been programmed.
Once the LED starts to flash rapidly
turn the key to the
OFF position
.
(
GMC
vehicle : Start the vehicle)
The LED will turn off to indicate the
module has been programmed.
The module is now ready for use.
(*Chrysler, Dodge, Jeep models
continue with step 7)
Connector 3 (White, located at the back of the
module):
Make the connections associated with the vehicle in
the VEHICLE FIT GUIDE (P.3-7)
Chrysler/Dodge/Jeep models
conn.
conn.
1.A
Connector 2 (White):
Make the connections associated with the vehicle in
the VEHICLE FIT GUIDE (P.3-7)
4
4
1
1
4
1
6
4
START HERE:
INSTALLATION AND PROGRAMMING INSTRUCTIONS
Front of the module
WIRING / CONNECTION GUIDE
See wiring schematic configuration
Back of the module
Make the connections of the DLPK
to the vehicle:
Connect
the other connectors
(
CONN. 2
)
(CAN High) Data
Trunk
Pink
Unlock
Light Green
Aux. 2
Slide door left White/Violet
Output 1
Blue/White
Output 2
Violet/White
Future Use
Trunk Output White/Red
Relay COM
Orange
Red/White
See Configuration
Blue
Lock
(-) While running (status)
Output 3
Relay NC
14
8
1
7
Violet/Black
Green
Grey
White/Black
Yellow
Tach
Aux. 1
~
~
*
Connector 1 (White):
Determine the type of installation:
INSTALLATION WITH OR WITHOUT D2D (See
P.8
)
7
PANIC
LOCK
UNLOCK
WARNING: Connector 2 can be easily
plugged in backwards.
WARNING: Connector 2 can be
easily plugged in backwards.
IGN
START
OFF
GM
TECHNICAL SUPPORT / INFORMATION
web resources:
www.xpresskit.com
www.directechs.com
Connect wire to Remote-Starter/Alarm
Programming
button
DLPK
CANBUS DOORLOCK AND IMMOBILIZER INTERFACE*
*RFLOOP may be required
P.1
4
conn.
D2D Cable
Connect to
Remote starter
1
2
3
Optional
Transponder
Bypass Connector
(
RFLoop Series
)
The module is now
ready for use.