1
Transmission
14
15
16
17
18
19
20
21
22
23
24
25
Battery charge indicator
2
Vehicle out of range
Auxiliairy outputs status
Sentinel mode status*
SECURITY SYSTEM STATUS*
ULTRASONIC SENSOR*
IGNITION STATUS SENSOR
TILT SENSOR*
Remote starter status
HOOD STATUS
TRIGGERED ZONES
Valet mode status*
Vehicle identification
3
Reception
4
Unlocking
5
Locking
6
P
*
MD
RE-ALERT
7
MD
Panic / PRE- ALERT * / ALARM**
8
ALARM
9
SHOCK SENSOR*
10 FIELD DISTURBANCE SENSOR*
11
TRUNK LID STATUS
12
GLASS BREAKAGE SENSOR*
1
2
3
4
5
6
15
24
23
22
21
20
19
18
17
8
9
10
11
12
13
16
14
25
7
13 DOORS STATUS
The LCD displays the vehicle status at all time, the display is refreshed on every transmission or when the status of the vehicle
changes pertaining that the “Status confirmation” function is enabled. The display shows the last confirmation received.
The following diagram shows the usefulness of each icon of the display. Descriptions in CAPITAL letters show confirmations
pertaining to the security system’s functions.
Two types of confirmations are displayed on the remote:
Command confirmation
: These confirmations are command acknoledgement, the icon corresponding to the command is
displayed to confirm reception of the command.
Status confirmations
: These confirmations are displayed when the status of a zone, monitored by the system, changes (i.e.:
door openning, security system alarm state (only if the Factory Alarm Trigger Monitoring feature is supported by the firmware), etc.
- it depends on which firmware you are using).
Command confirmations are returned immediatly following a command transmission whereas the status confirmations may be
returned up to 12 seconds after the event appened depending on the communication protocol between the hand-held unit and the
vehicle.
Remarks
: When the remote receives a confirmation that is intended to a vehicle other that the one actually selected, most audible
confirmations are made more descret, vehicle icon flashes (1-4) to warn you that the display reflect the status of that specific
vehicle. This is only applicable if
When a command is transmitted, the vehicle selection gets back to the previously selected unless the confirmation was related to
an alarm condition.
In that case the selected vehicle is temporarely changed, to allow stopping the alarm condition without having to change the
vehicle selection, then gets back to previously selected when the alarm condition is stopped.
Out of range
: In the event that the environement prevents the confirmation from being received by the remote control, all icons
are cleared out. In this case, resend the command or send the status command to refresh the display.
the Factory Alarm Trigger Monitoring feature is supported by the firmware.
* These features are not available with the XL202 module.
** Only if the Factory Alarm Trigger Monitoring feature is supported by the firmware.
Upon Entering your Vehicle
DO NOT TURN IGNITION KEY TO
START
POSITION.
To avoid turning the engine off when taking place behind the
steering wheel, do not apply the brakes until you have placed
the key in the ignition and turned it to the RUN position.
To avoid turning the engine off when taking place behind the
steering wheel, do not apply the brakes and do not remove the
parking brake until you have placed the key in the ignition and
turned it to the RUN position.
Drive as usual.
Drive as usual.
Automatic transmission vehicles
Manual transmission vehicles
Page 3
Understanding the Confirmations Emitted by the Remote
2-Way LCD (XRT) Remote Start and Security System with One Mile of Range
Rev.: 20091103
© 2009 Directed Electronics. All rights reserved.
MODEL: AstroStart RSS-5224
