https://www.XPOtool.com
Item 61955
Page 13
The Tool Experts
05 2022-1
Starting a cold engine
1.
Move the throttle lever
(1)
to the idle position.
2.
Slowly push the primer pump six times.
3.
Set the start lever to the “Start” position.
№
Name
№
Name
1
Starter rope
2
Primer
4.
Pull the starter handle vigorously, in a controlled manner, and evenly 6
times (at temperatures
above 32
℃
no more than 3
times!). If the engine starts before pulling the starter handle 5
times,
run the engine for 5
s. Then push the throttle lever completely to deactivate the start system
(the start lever returns to the “run” position). Step
5 is then not required.
5.
Pull firmly on the starter handle while squeezing the throttle until the engine starts and runs.
Starting a warm engine
1.
Press and hold the throttle lever.
2.
Pull firmly on the starter handle while pushing the throttle lever until the engine starts and runs.
Note:
Normally, the warm start can be still carried out approx. 5–10
minutes after the device has been
switched off. After a downtime of more than 10
min, start the device after cold start procedure or follow
the start instructions printed on the unit.
Starting a stalled engine
Engines can be started by moving the start lever to the “run” position and pressing the throttle fully. Pull
the starter lever repeatedly while depressing the throttle until the engine starts and runs. This may