https://www.XPOtool.com
Item 61955
Page 10
The Tool Experts
05 2022-1
№
Name
№
Name
1
Flap
2
Notch
4.
Push the upper suction tube into the suction opening. Rotate the tube to the right until it clicks
securely into place on the suction cup and is firmly seated.
5.
Arrange the bevelled end of the suction tube as shown. Push the lower into the upper suction
tube until the lower suction tube is firmly seated in the upper suction tube (approx. 7
cm). After
pushing the two suction tubes together, position the marking on the lower part of the upper tube.
Screw the two tubes together using the screw provided.
Warning:
Before starting the engine, both the lower and upper vacuum tubes must be installed and
each section of the tube be screwed in place.
Converting from leaf vacuum to leaf blower
1.
Loosen the connecting pipe by turning the knob to the left and remove the connecting pipe and
the collection bag.
2.
Turn the suction tubes clockwise and pull them off.
3.
Close the lid of the suction opening; make sure the lid is locked into the tab.
4.
Assemble the blowpipes again (see section “Assembling the blower pipe”).
Adjusting the shoulder strap
1.
When vacuuming or blowing, always hold the device so that the exhaust pipe is kept away from
your body and clothing.
2.
Place the shoulder strap over your head on your right shoulder.
3.
Grasp the back of the collection bag with your left arm.
4.
Adjust the shoulder strap so that the bag/shoulder strap seam lies between the thumb and fore-
finger.
5.
Make sure that the shoulder strap is adjusted to allow unobstructed airflow out of the connecting
tube. If the collection bag is bent, the device will not work properly.