xTAG v3.0 Hardware Manual
I N T H I S D O C U M E N T
·
Introduction
·
XS1-U8 device
·
xSYS Connector (J2)
·
J3 and J4 connectors
·
24MHz Crystal Oscillator
·
I/O Port-to-Pin Mapping
·
xTAG v3.0 Schematic
1
Introduction
The xTAG v3.0 debug adapter converts between an XMOS XSYS connector and USB
2.0, providing pins for JTAG control, system reset, processor debug, one duplex
UART link and one duplex serial XMOS Link. The xTAG v3.0 debug adapter can
be used to connect XMOS development kits to most PCs, and provide a 5V power
supply from a USB 2.0 port.
The diagram below shows the layout of the components on the card.
20-way
IDC xSYS
connector
Standard
USB-B
connector
LEDs
J1
J3
J4
J2
Figure 1:
xTAG v3.0
features
To debug a board with the xTAG v3.0 you must use xTIMEcomposer 13.1 or later,
available from the XMOS web site:
http://xmos.com/downloads
.
The board requires an XMOS xSYS connector.
Publication Date: 2015/6/1
Document Number: XM006125A
XMOS © 2015, All Rights Reserved
