9
8. Inject liquid into XMG OASIS
1.
Open the refill port cover on the main unit. Place the funnel into the
bigger of the two holes and slowly pour the recommended coolant
liquid solution into the funnel.
2.
Observe the water level through the vertical lens on the front of the
main unit. Pour liquid until the water level reaches the “Maximum”
line, marked near the top of the lens.
3.
Verify that the water tubes of XMG OASIS are firmly connected to
your host laptop before proceeding.
4.
Press and hold the power button of XMG OASIS for 5 seconds. The
power button will blink in purple color, indicating that it has entered
“Liquid Input Mode”. During this mode, the pump will work to push
liquid from the reservoir into the cooling loop.
5.
The water level behind the front lens will drop. Add additional liquid
until the water level stabilizes about
1
cm below the “Maximum” line.
6.
XMG OASIS will automatically leave “Liquid Input Mode” after a few
cycles. Press and hold the power button again for 5 seconds to
repeat this operation. Running multiple cycles might help to push all
remaining air bubbles out of the loop, resulting in a quieter operation.
7.
When everything is done, recap the refill port cover. Check all
connections of the loop for any residual leakage – there should not
be any liquid drops on the chassis or on the surface below.
Water injection hole
←
Maximum
←
Optimum
←
Minimum