XM Controls Tandem-Wire, Руководство по эксплуатации

Страница: 21 / 41

6.2.5.4 Motion Buttons
Set Position - When this button is pressed, the POSITION 1 and
POSITION 2 buttons are made ready for programming. To program
position torch where desired, press SET POSITION, and then press
the POSITION 1 or POSITION 2 button. The current position will
be saved to the corresponding button.
Position 1 and Position 2 - Moves the torch to a previously saved
position (See “ Set Position ” above). All motion axis involved in
torch positioning will be affected.
Cross Home - Moves the Cross Slide to its hardware home position
and zeros the position readout.
XVC Home - Moves the XVC Slide to its hardware home position
and zeros the position.
Home All - Moves all slides (or rotation devices) with Home
capabilities to their hardware home positions and zeros the position
readout.
High Speed - Changes the jog speed of all motion axes that are
controlled by joysticks. Changes JOG buttons to the HIGH SPEED
setting.
Continuous Jog - Illuminates when active and is used in
conjunction with the Jog buttons (see 4.5.4). With the
CONTINUOUS JOG activated, the TRAVEL JOG or WIRE JOG
buttons will operate continuously at the programmed rate until
canceled. To cancel the CONTINUOUS JOG mode, either press the
Stop button or deactivate the CONTINUOUS JOG button and then
press the TRAVEL JOG or WIRE JOG button that was being used.