XLT Ovens XLT TS3-S Standard Series, Руководство по установке и эксплуатации

Страница: 19 / 36

XD-9010-TS3-S Rev A 04/2009 18
Installation & Operation Manual
5. INSTALLATION
5.1. INSTALLATION OVERVIEW
The following is an overview of the installation process.
1. Read this manual thoroughly.
2. Make sure all electric, gas, and ventilation utilities are adequately sized and in place before the
oven arrives.
3. Inspect the oven and crates for freight damage upon arrival. Assemble the oven on its base
near the area of intended usage. Remove all combustibles and obstructions from the area.
4. Have your plumber make all gas connections per local building codes. Provide adequate
clearance to access the gas shut off valve. Check for leaks!
5. Have your electrician make all electrical connections per local codes. Provide adequate
clearance to access the electrical plug and receptacle.
6. Install a restraint device and make sure that it guards against transmission of strain to the gas
line and electric cord.
7. Test the exhaust hood using a smoke candle to determine the amount of combustion products
removed.
5.2. PURCHASER’S RESPONSIBILITY
Note: All installations must conform to local building and mechanical codes.
It is the responsibility of the purchaser:
1. To see that the gas and electric utilities are installed on site in accordance with local
mechanical codes and with the specification in this manual.
2.
To unload, uncrate, move, and assemble the oven(s) in their intended location.
3. To see that the gas and electric utilities are connected properly and using the proper hardware
by a qualified installer.
5.3. ASSEMBLY INSTRUCTIONS
These ovens come completely assembled from the factory except for Product Stops. The product
stops are shipped loose inside the oven. Remove them prior to start and install on the exit end of
the conveyor. Detailed assembly instructions are available, contact XLT Customer Service.