XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 5
4.3.
EAS Unit Installation
The installation procedure of the EAS unit is listed below for the Discovery 3/4 vehicle.
The Range Rover Sport’s original EAS control unit is located about 10cm lower than in the
Discovery.
For convenient access to the connectors, it is necessary to remove the footwell and the
adjacent left panel (the one with the front bonnet open handle).
Estimated installation time:
●
The EAS unit installation should take approximately 20 minutes.
Tools required:
●
Common cross-head screwdriver (e.g. original from Land Rover equipment).
●
Flashlight - Installation area lighting
EAS unit installation procedure:
1.
Disconnect the vehicle battery according to the vehicle user manual (optional)
a.
Make sure the ignition is off.
b.
Disconnect the + pole.
c.
Wait 1 minute.
Note: This is not really required, installing without disconnecting the battery does not
cause problems.
2.
Dismantle the lover dashboard cover panel under the steering wheel.
If installing to the Range Rover Sport L320, see the note above.
a.
Unscrew the two screws holding the cover.
b.
Pull in the direction of the RIGHT green arrow (see picture below) to release a
mechanical connector connecting the cover to the central tunnel.
c.
Hold the cover panel in the centre. Pull down and towards you slightly to move
the cover panel down for approximately 10 centimetres.
d.
Disconnect the light connector located on the left side (right for RHD vehicles) of
the cover.
e.
Remove the entire cover.
