XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 3
3.
Safety information
This manual contains important information on the installation and use of the XLifter.
Please take some time to read this section to fully utilise the XLifter features and to ensure
that you know how to operate it safely. Use the XLifter only for its intended purpose as
described in this user manual.
What the safety symbols in this user manual mean:
This symbol represents potential general warnings, hazards or unsafe practices
that may result in possible damage to vehicle or vehicle systems.
Please read texts
marked by this symbol carefully and proceed according to provided
instructions to avoid risks.
Warning:
This symbol, with the word "warning" attached above or next to the
symbol, indicates situations where non-compliance may result in serious injury or
damage to the equipment or vehicle.
Safety instructions are described on a continuous basis in the description of each XLifter
function. However, below is an overview of the most important ones:
General warnings:
Warning:
Ensure that the XLifter is operated only by a person familiar with this manual. If
another person is driving, please activate the Keylock function before driving, as a safety
measure.
(see chapter 5.4)
Warning:
If an XLifter is left installed in the vehicle when it is sold, notify the new acquirer
and familiarize him with this manual. Please keep this manual in the vehicle in an
accessible location for a future reference.
Warning:
Do not use XLifter while driving on the public roads. Do not lower or raise the
vehicle at high speeds.
Warning:
When using the XLifter mobile application, same warnings applies. There is no
difference when you control the XLifter from the control module or mobile app
Warnings for the lifter and lifer-free functions:
Warning:
Don’t overstress the CV joints
when in extreme lifts
- “Sky Rocket” (+75 mm) or
any lift program while the “original” vehicle height is engaged in Off Road.
Be gentle with
the accelerator pedal when you have low-range engaged
and you are steering
excessively to the left or right with.
Warning:
In the original “Off Road” vehicle height, it is not recommended to lift the vehicle
with XLifter by more than +25 mm permanently due to possible increase wear of the air-
springs.
Warning: Be gentle to the vehicle compressor!
The compressor will overheat when the
vehicle is lowered/raised several times (3x is enough) in a row. When overheated to approx.
130 °C, the Land Rover EAS unit inhibit further operation until cooled down. Cooling takes
about 10 minutes.
Watch the compressor temperature!
Warning for the levelling function:
Warning: NEVER start the levelling function while driving.
The wheels height will be set
differently, which results to potentially dangerous situation. Start levelling
ONLY
when the
vehicle is stationary.
When active, the levelling function must be exited before driving.
Otherwise you start
driving with unbalanced wheel heights, exposing yourself to potentially dangerous
situations and you may even damage your vehicle.
NEVER leave the camping place with
levelling still active!
Do not engage electronic park break (EPB) before or during levelling. It will cause
unnecessary tension on the park brake cables, which will counteract wheel movement.
You may use the features in park mode without the brake engaged.
Warning:
Close all doors before starting the levelling function to prevent possible damage
due to contact with surrounding obstacles/obstructions.
