XKL DarkStar DBA-L, Руководство пользователя

Страница: 25 / 72

15
DarkStar User Guide
2: Hardware
www.xkl.com
Tx
Rx
cap fiber
4
5
6
Remove the fiber pair from the
laser module and cap each
connector. Make note of
connection placement to
ensure Rx and Tx connections
are properly reestablished at the
end of this procedure. Push down on the latch
mechanism to release the laser
from its cage. The latch snaps
when it is open. Note that the
latch mechanism may vary
depending on the type of laser
in the system. 4
5
6 Slide the laser out of the cage.
Tx
Rx
>_
show interfaces
Important!
7
8
9
Insert the replace m ent laser
m odule into the cage. It will
click when properl y seated.
It m a y be helpful to
co m pare its align m ent with
adjacent lasers to verif y
correct installation.
8
7
Clean the fiber ends with an
approved fiber cleaner (a
fiber cleaner is included with
the DXM). In a single step for
each connector, clean the
fiber and insert it in the laser
m odule. Do not clean or
insert both fibers at the
sa
m e ti m e.
9
Visuall y inspect the R x and T x
fibers are properl y inserted.
Running the
show
interfaces
co mm and will
verif y the laser is properl y
seated. The reported R x
power level show level
should be si
m ilar to the other
wave lasers.
!