3. XJLink2-3030 Module Installation
Please follow normal anti-static handling procedures at all times.
Make sure that the board stiffening bars have been fitted (see
Figure 1
earlier), and that the Carrier Board
is fully supported when each XJLink2-3030 module is inserted. Failure to do so could result in damage to
the Carrier Board.
Remove the screws and washers used for securing the XJLink2-3030 module(s) from the Carrier Board,
retaining them to secure the module after it has been inserted. Carefully align the connectors on the
XJLink2-3030 module with the connectors on the Carrier Board (see
Figure 4
for the correct orientation
of the module) before firmly pressing downwards until the module touches the four mounting screw
points on the Carrier Board. Reinsert the screws taking care to keep the washers in the correct order
(XJLink-3030/fibre washer/metal washer/screw), as shown in
Figure 3
below.
Figure 4 below shows a Carrier Board with an XJLink2-3030 module installed. If only a single XJLink2-3030
module is going to be used it is recommended that it be fitted as module 1. However as each module
connects to pre-defined pins on the system connector, the XJLink2-3030 module must be installed in the
correct slot for the fixture being used.
page 4 of 8
XJTAG-3030-Guide-20C-01
www.xjtag.com
SPEA 3030 XJLink2 Carrier Board
.
User Guide
Figure 3 – Screw and washer assembly for fitting an XJLink2-3030 module
Figure 4 – Carrier Board with a single XJLink2-3030 module installed
