2. Display
XiteSolutions North America Inc.
8
2.1 Main Monitor Display
Functions:
Bluetooth Microphone
LDR (light dependent resistor) and IR (infra-red) receiver
1.
LDR is used for the dimming of the display and is active when Auto dim in
System Settings is set to Sensor
2.
IR receiver is used with remote control operations
MENU
1.
Tap MENU button once to go to the Main Menu (or Home Page)
2.
When in the Main Menu, you can either use the touch screen to select the
desired icon (source) or you can keep tapping the Menu button to select
different icons on the screen. When icon is highlighted for more than 1
second, the system will automatically open that icon
3.
You can also access the Main Menu from any screen by tapping the
function icon in the top left corner of the current screen
Note: When viewing video in full screen, touch the screen once to bring up the icon
header which will display the function icon. Tap the icon to return to the Main Menu
NAVI
1.
Press the NAVI button once to go to the navigation system
2.
While viewing your navigation press the NAVI button to return to the
active source (Radio, or SXM, or Bluetooth, etc.). If the navigation route is
running, navigation audio voice prompts will continue to be heard over the
speakers according to the Navigation audio settings you have selected in
the Settings menu (See section 3.3 of this manual for more information).
3.
To hear only the navigation audio voice prompts, press and hold NAVI
button for 2 (two) seconds. This will mute the active source until you
leave the navigation screen.
CAM
1.
Press the CAM button to switch to camera view. Press gain to exit the
camera view
FAV
1.
You Infotainment Center is equipped with a favorite source hotkey. Press
the FAV button once to directly access your favorite audio source.
2.
Favorite audio source is defaulted to Sirius XM, and it can be changed by
going to
Setup -> System -> Favorite Mode
.
Rotary button VOLUME / MUTE / POWER
1.
Turn on the ignition to power up the Infotainment Center. The buttons on
the front of the unit light up. When the Infotainment Center is started up, it
will immediately go to the last mode (memory on playback) before it was
turned off.
2.
Turn the rotary button left/right to adjust the VOLUME to the desired level
3.
Press and release the rotary button once to MUTE the volume. Press and
release again to UNMUTE
4.
In order to put the unit in standby mode, press and hold the rotary button
for more than 2 seconds. During standby, the display will show your
vehicle graphic or be off. Your preference can be set in the Settings menu
(See page 10). Press and hold the rotary button again to turn the unit on.
5.
In order to turn the unit off completely remove ignition key and/or ensure
any auxiliary battery power to the system is turned off.
5
6
7
1
2
3
4
4
5
7
6
3
2
1
