Xilinx Varium C1100, Руководство по установке

Страница: 9 / 26

1. Shut down the host computer and unplug the power cord.
2. Open your computer by removing the casing.
3. If necessary, remove the adjacent PCIe ® slot cover corresponding to the PCIe slot in which
you are installing the Varium C1100 compute adaptor.
4. Plug the Varium C1100 compute adaptor into the PCIe x16 slot on the motherboard.
5. Connect the AUX power connector to the Varium C1100 compute adaptor, ensure the plug is
mechanically fixed (with the click).
IMPORTANT! Operation of the Varium C1100 compute adaptor only with AUX power connector is
not allowed.
IMPORTANT! Le fonctionnement des adaptateurs Varium uniquement avec le connecteur auxiliaire
n'est pas autorisé.
WICHTIG! Der Betrieb von Varium-Adaptern mit dem Hilfsstecker ist nicht zulässig.
To provide additional power, the Varium C1100 compute adaptor has an 8-pin female PCIe
AUX power connector which can accept an 8-pin or 6-pin AUX power cable. For applications
requiring optimum performance, the PCIe AUX power needs to be connected to increase the
power supplied to the adaptor from 75W from the PCIe to 150W. Consult your computer
documentation for additional information.
6. Re-install the computer casing.
7. Connect the power cord and turn on the computer.
WARNING! Do not power-on a passively cooled card without adequate forced airflow across the card
with proper air flow direction, otherwise the card can be damaged. This card can heat up after use in
the server. Use caution when handling. For more information, see Varium C1100 Compute Adaptor
Data Sheet (
DS1003 ).
8. To verify that the device has been installed correctly, enter the following command in the
terminal:
$ sudo lspci -vd 10ee:
If the adaptor is successfully installed and found by the operating system, a message similar
to the one below will be displayed.
This is a sample output for an installed Varium C1100 compute adaptor:
af:00.0 Processing accelerators: Xilinx Corporation Device 5058
Subsystem: Xilinx Corporation Device 000e
Flags: bus master, fast devsel, latency 0, NUMA node 1
Memory at 39bffc000000 (64-bit, prefetchable) [size=32M]
Memory at 39bffe000000 (64-bit, prefetchable) [size=128K]
Capabilities: <access denied>
Kernel driver in use: xclmgmt
Kernel modules: xclmgmt
Chapter 3: Adaptor Installation Procedures
UG1525 (v1.1) March 8, 2022 www.xilinx.com
Varium C1100 Compute Adaptor Installation Guide 9
Send Feedback