2
• Solder the lead wires to the tape light, keeping the correct
polarity.
• For these procedures, it is recommended that basic wiring
techniques are followed.
3
• Fill the end cap halfway with a non-acidic neutral silicone sealant,
such as Loctite Superflex SI 5050CL, Dow Corning 737 or
Momentive RTV-11.
• If sealing the wired side of the LED tape, place a small puddle of
sealant where the wires connect to the strip.
4
• Insert the end cap on the end of the strip until the back wall of the
end cap is touching the end of the strip.
5
• Allow 24hrs for the silicone sealant to fully cure.
RE-SEALING IP67 XFL (CONTINUED)
Rev 1.2 | February, 2022
7
WET LOCATION
DC ONLY
XFL Flexible Linear LED Light Installation Instructions