Xerox WORKCENTRE 7428, Руководство системного администратора, Страница: 52 / 208

Network Management
WorkCentre 7425/7428/7435
System Administrator Guide 52
Microsoft (NetBIOS over IP) Networks
Before You Start
1. Print a Configuration Report. See Configuration Report on page 22.
2. Referring to the report, verify that SMB is enabled. To enable SMB at the printer, if required, follow
the procedure below.
3. Referring to the Configuration Report, verify that DNS is enabled. The use of Naming Servers is
required to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
4. To enable the printer to communicate with the Naming Servers, see TCP/IP Dynamic Addressing on
page 48.
5. When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling SMB Setting at the Printer
1. Press the
Log In/Out
button on the control panel.
2. Enter the
System Administrator’s Login ID
and
Passcode
if prompted (default
admin
,
1111
), and
press Enter .
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup .
6. Press Port Settings .
7. When the Port Settings menu displays, press the SMB selection line.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the SMB selection menu displays, note that you have only one setting available on a single,
numbered horizontal line. Press this selection line.
10. Press the
Change Settings
button.
11. On the SMB Port Status screen, note which of the two buttons is highlighted as the current setting
for SMB Enablement. The available settings are Enabled or Disabled. To enable SMB at the printer,
select the
Enabled
setting.
12. Press the
Save
button on the touch screen, which returns you to the SMB selection menu. (To exit
the screen, without making changes, press the Cancel button.)
13. Exit the SMB selection menu and return to the Port Settings menu by pressing the Close button in
the upper right corner of the touch screen.
14. Exit the Port Settings menu by pressing the
Close
button in the upper right corner of the Port
Settings menu screen.
15. To exit the Tools screen, wait several seconds for the Auto Clear service to log you out.