Xerox WorkCentre 3025BI, Руководство по обслуживанию

Страница: 81 / 156

June 2014
4-29
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
REP 1.15, REP 1.16
Repairs
4. Removing the Feed Sensor Actuator ( Figure 2 ):
Note the location of the Spring in the frame cutout for reinstallation.
a. Unlatch and remove the actuator.
5. Removing the Width Actuator ( Figure 2 ):
Note the location of the Spring in the frame cutout for reinstallation.
a. Unlatch and remove the actuator.
Figure 2 Sensor Actuators and Springs (Rear View)
Replacement
Install the components in the reverse of removal.
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
NOTE: Make sure that the Actuator Spring is location in frame cutout ( Figure 2 ).
REP 1.16 Paper Tray
Parts List on PL 5.1
Removal
1. Remove the following covers:
a. The Front Cover (REP).
b. The Left and Right Side Covers Cover (REP).
2. Remove the Paper Tray Screw (1) from the Left Frame ( Figure 1 ).
Figure 1 Paper Tray Screw (Left View)
NOTE: Use a small screwdriver to help release the Paper Tray from the frame.
3. Remove the Paper Tray ( Figure 2 ).
a. Release the Paper Tray from the Left Frame.
b. Release the Paper Tray from the Right Frame.
Spring
Latch
Width Sensor Actuator
Feed Sensor Actuator
Spring
Screw